Hunter Builder Low Profile Instruction Manual page 5

1
While holding the wires out of the way, lift the
motor assembly and place the square hanger
into the opening in the ceiling bracket. Be sure
the ground wire attached to the hanger faces
out of the large opening in the ceiling bracket.
We know wiring is hard. Let's make it easier.
Follow these steps to get your fan wired quickly and safely. Follow the route be-
low that best matches your wall switch setup. If you are unfamiliar with wiring or
uncomfortable doing it yourself, please contact a qualified electrician.
Have a single switch?
Follow these steps:
Connect the three
grounding wires (green,
green/yellow stripe, or
bare copper) coming from
the ceiling and hanging
bracket.
WARNING
The ceiling fan must be grounded. If the
ground wire for the installation site is not
present, immediately STOP installation and
consult a qualified electrician.
Have dual switches?
Follow these steps:
Connect the second
ungrounded (light)
wire from the
ceiling to the blue Blue
wire from the fan.
Connect the three
grounding wires (green,
green/yellow stripe, or
bare copper) coming from
the ceiling and hanging
bracket.
Ceiling Bracket Hanging Fan
Grounding
WARNING
All wiring must be in accordance with
national and local electrical codes ANSI/NFPA
70. If you are unfamiliar with wiring or in
doubt, consult a qualified electrician.
Grounding
Wiring
Hanging the Fan
2
Once the motor is in the ceiling bracket,
use the two locking screws found in the
hardware bag to secure the motor
to the ceiling bracket.
Wiring the Fan
Black
Hunter Pro Tip:
Have extra wiring?
Turn the wires upward and push them carefully back through
the hanger bracket into the outlet box. Spread the wires apart,
with the grounded wires on one side of the outlet box and the
ungrounded wires on the other side of the outlet box. Make
sure that the wires are still attached to the wire nuts.
Motor Housing
Hunter Pro Tip:
Here is how to connect the wires:
Push the bare metal ends of the wires together and slide a wire
nut over them. Then, twist the wire nut clockwise until tight.
Give it a gentle pull to make sure none of the wires are loose.
Connect the white
(grounded) wire from
the ceiling to the white
wire from the fan.
White
Connect the black wire
(ungrounded) from the
ceiling to the black and the
blue wires from the fan.
Connect the white
(grounded) wire from
the ceiling to the white
White
wire from the fan.
Connect the black wire
(ungrounded) from the
ceiling to the black
Black
wire from the fan.
Blades
1886
x2
bag
Locking
Screw
x4
bag
Wire Nut
x4
bag
Wire Nut
4
Light