Advertisement
Available languages
Available languages
Symbol
Power tool designation
The power tool has been designed to unscrew and
to tighten threaded fastening elements (bolts, nuts,
screws, bolt screws, etc�)�
Power tool components
1 Indicator
2 Reverse switch
3 On / off switch and torque regulator
4 Body
5 LED lamp
6 Tool holder (with magnet)
7 USB socket (type C)
8 USB cable *
9 Magnetic holder *
10 Carrying bag *
11 Screwdriver bit *
12 Power unit *
* Optional extra
Not all of the accessories illustrated or described
are included as standard delivery.
Installation and regulation of power tool
elements
Mounting / replacement of accessories (see fig. 1)
Mount / replace the accessories into tool holder 6, as
shown onto fig. 1. Attention: the tool holder 6 has a
built-in magnet, therefore it is not recommended to
install double-side screwdrivers into it. They can
not be securely fixed in the tool holder 6 due to
the small contact area of the screwdriver end with
the magnet, while the end of the screwdriver can
destroy the magnet.
Meaning
Attention� Important�
A sign certifying that the
product complies with es-
sential requirements of the
EU directives and harmo-
nized EU standards�
Useful information�
Do not dispose of the power
tool in a domestic waste
container�
Charging procedure of the power tool
battery
Initial operating of the power tool
The power tool is supplied with a partially charged
battery. Before the first use, the battery must be fully
charged.
Charging (see fig. 2)
• Connect the plug of USB cable 8 to socket 7
(see fig� 2)� Connect USB cable 8 to suitable power
unit 12 or USB socket�
• During charging indicators 1 will blink one-by-one
(showing state of charge of the battery)� When charg-
ing is complete, all indicators 1 will light up�
• When charging is complete, unplug USB cable 8
from socket 7 and disconnect USB cable 8 from power
unit 12 or USB socket�
During charging the battery of the power
tool and power unit 12 may become hot - it
is no problem.
You can't use the power tool during
charging - it will not turn on.
Switching the power tool on / off
Make sure that the reverse switch 2 is not centred,
this blocks on / off switch of the power tool. Before
switching on the power tool, select the direction of
rotation by moving the reverse switch 2 forward or
backward (see below).
Switching on / off with button
Switching on:
Set the reverse switch 2 to position "F" or "R", then
press and hold on / off switch 3 (see fig. 3.1, 4.1).
Screwdriver bit 11 will start to rotate�
Switching off:
Release on / off switch 3 (see fig. 3.2, 4.2).
Switching on / off when pressed
Switching on:
Set the reverse switch 2 to position "F" or "R", then
install an screwdriver bit 11 into the slots of the
fastener, press the power tool and hold it in this
position (see fig. 5.1). Screwdriver bit 11 will start to
rotate�
Switching off:
Loosen the pressure on the power tool (see fig. 5.2).
Design features of the power tool
Battery
The battery of the power tool is protected by the
safety system against deep discharge� In case of
English
19
Advertisement
