Table of Contents
Advertisement
Configure the Management Interface from the
Management Port
Configure the Management Interface from the Management Port
Before You Begin
Note
The ExtremeCloud IQ Controller E3125 must be upgraded to the latest
ExtremeCloud IQ firmware before installing the controller on the network.
You will need a laptop.
About This Task
You can retain the default IP address of the controller management interface if you do
not connect the controller to your enterprise network. If you connect the controller to
your network, follow these steps:
Procedure
1. Connect a laptop to the controller's management port.
2. Configure the Ethernet port of the laptop.
Use a statically assigned unused IP address in the 192.168.10.0/24 subnet.
3. Enter https://192.168.10.1:5825 into a web browser address bar.
192.168.10.1 is the default IP address on the controller management port.
The ExtremeCloud IQ logon screen displays.
4. Log on the ExtremeCloud IQ.
The default user name is admin and the default password is abc123
5. Complete the installation to configure the E3125 controller for new deployments.
6. Disconnect your laptop from the controller.
7. Connect the controller management port to the enterprise Ethernet LAN.
8. Log on to Extreme Networks.
Connect the Data Ports
Before You Begin
Ensure that the network device at the other end of the segment is powered On.
About This Task
Connect the ports to your network so the controller is active and functioning. The data
ports are located at the back of the controller.
26
ExtremeCloud™ IQ Controller E3125
Note
The system is now visible to the enterprise network. Refer to the
ExtremeCloud IQ User Guide on the
for more information.
Initial Network Connection and Configuration
Extreme Networks Documentation Site
Advertisement
Table of Contents
