Toro Groundsmaster e3200 Installation Instructions Manual page 4

Figure 6
Machine with 13 installed batteries shown
1. Battery ports (labeled D2)
3. Remove the appropriate amount of caps from
the bus bars (Figure
Figure 7
1. Caps (removed for
machine with 13 batteries)
4. Perform the following steps to install the bus
bars:
A. Use the previously removed bolts to loosely
secure the bus bars to the batteries
3).
B. Use the previously removed hardware to
install the battery cables to the bus bars
(Figure 3)
2. Wire harnesses
7).
2. Caps (removed for
machines with 15
batteries)
(Figure
C. Use the bolts included in the kit to loosely
secure the bus bars to the new batteries
(Figure
g452835
Machine with 13 installed batteries shown
1. Bolt
2. Upper bus bar
5. If your machine has 13 installed batteries:
A. Use the previously removed bolts to install
a battery spacer to the battery-compartment
gap
g455916
1. Bolt
B. Install the wire harness (shown in
that you removed in the previous procedure
4
8).
Figure 8
3. Lower bus bar
(Figure 9).
Figure 9
2. Battery spacer
g452847
g456289
Figure 2)