How To Use - BenQ ScreenBar Halo User Manual

3. Open the battery compartment cover at the bottom of the
wireless controller and insert the three AAA batteries provided
(please make sure that the batteries are inserted with the correct
polarity) and then install the battery cover back.
• Do not mix old and new batteries.
• Do not place the batteries under direct sunlight, at a high
temperature or near fire. Neither store the batteries in high
humidity nor submerge them in water.
• Do not disassemble, hit, or make modifications to the batteries or
they may short circuit and pose a hazard.
• Do not attempt to recharge discarded non-chargeable batteries
or expose them to fire.
• Remove the batteries if they are depleted or if the lamp will not be used for an extended
period; otherwise chemicals inside the batteries may leak and damage the product.
• To reduce adverse impact on the environment and prevent health hazards, please properly
discard the batteries according to your local recycling regulations.
• It is recommended to use alkaline batteries to extend the life of the controller.

How to Use

Turning On/Off the Lamp and Switching Light Modes
Power On/Off
Light Mode Control
Auto Dimming Mode
Adjusting Brightness and Color Temperature
Brightness Control
Dark
2 English
Tap the Power
Power button again.
When the remaining battery charge is low, the power indicator will flash
to remind you to replace the batteries.
Tap the Light Mode Switch
light modes:
Front light on > Ambient light on > Both lights on
Tap the Auto Dimming Mode button
will light up when the mode is on. In the Auto Dimming Mode, the light mode
(front light/ambient light/both) remains the same while the lamp automatically
adjusts its brightness according to the surrounding lighting condition and sets
the color temperature to 4000K.
• Avoid blocking the light sensor located on the lamp
to ensure that the Auto Dimming Mode works
correctly.
• The Auto Dimming Mode will automatically turn off
when you adjust the brightness or the color
temperature or switching light modes. The Auto
Dimming Indicator will turn off when the mode is off.
Bright
Tap the Brightness Adjustment
control. The indicator will light up when the brightness control is on.
Rotate the adjustment ring to adjust the brightness and the lights around
the adjustment ring will change accordingly. Rotate the adjustment ring
clockwise to increase the brightness, or counterclockwise to decrease the
brightness.
button to turn on the lamp. To turn off the lamp, tap the
button to cycle through the following three
3
to enter this mode. The indicator
button to activate brightness