Alarm Reset - Supermicro X6DAL-G User Manual

Alarm Reset

The system will notify you in the
event of a power supply failure.
This feature assumes that Super-
micro redundant power supply
units are installed in the chassis.
If you only have a single power
supply installed, you should dis-
able this (the default setting) with
(CN1) to prevent false alarms.
See the table on the right for
jumper settings.
Serial ATA Enable/Disable
(X6DAL-TG)
Jumpers JPS1 allows you to enable
or disable the Serial ATA headers.
The default setting is pins 1-2 to
enable all four headers.
table on the right for jumper set-
tings.
See the
Alarm Reset
2-21
Chapter 2: Installation
Alarm Reset Jumper
Settings
Jumper
Position Definition
Open Enabled
Closed Disabled
Serial ATA Enable/Disable
Jumper Settings
(JPS1) (*For Marvell's
SATA Controller)
Jumper
Position Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
SATA Enable