Table of Contents
Advertisement
Installation Requirements
Location Requirements
WARNING
Explosion and Fire Hazard
Keep flammable materials and vapors, such as
gasoline, away from appliance.
Failure to do so can result in death, explosion or fire.
IMPORTANT: This refrigerator is designed for
indoor, household use only.
Temperature
This refrigerator is intended for use in a location
where the temperature ranges from a minimum
of 16°C to a maximum of 43°C. The preferred
room temperature range for optimum
performance, which reduces electricity usage
and provides superior cooling, is between 16°C
and 32°C. It is recommended that you do not
install the refrigerator near a heat source, such as
an oven or radiator.
Exterior and Dimensions
A
B
7 2 5 m m
Refrigerator doors
A
Handles
B
Freezer door
C
Convertible door
D
Ventilation
Adequate air circulation around the refrigerator
is required for efficient operation.
To ensure proper ventilation, maintain the
recommended clearances.
12
91 2m m
C
D
Recommended Clearances
B
B
C
100mm Above
A
B
50mm Behind
C
50mm Each Side
Note: If you place the refrigerator next to a fixed
wall, leave 1471.4mm minimum space to allow the
door to swing open.
Electrical Requirements
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove the ground prong from the power
cord plug.
Do not use an adapter.
Do not use an extension cord.
Failure to do so can result in death, fire or
electrical shock.
Before you move your refrigerator into its final
location, it is important to make sure you have the
proper electrical connection.
Recommended Grounding Method
A 220-240 volt, 50 Hz, AC only 15- or 20-amp
fused, grounded electrical supply is required. It is
recommended that a separate circuit serving only
your refrigerator be provided. Use an outlet that
cannot be turned off by a switch. Do not use an
extension cord.
NOTE: Before performing any type of installation
or cleaning, disconnect the refrigerator from the
electrical source. When you are finished,
reconnect the refrigerator to the electrical source
and reset the temperature controls to the desired
setting.
A
C
Advertisement
Table of Contents
