BROKIS LIGHTLINE PC981 Quick Start Manual

Package contents

Name: LIGHTLINE PC981
Table Light
Components
included with unit:

Assembly

The manufacturer assumes no liability for damage resulting from failure to adhere to the
steps described in this manual. When unpacking the light, do so with regard for its ma-
terial composition – the main components are made of glass and very fragile materials.
1.
Use the provided cotton gloves when removing the light from its package.
In order to avoid damaging the glass, ensure that the rubber seal is positioned on the glass shade
(Fig. *1A). Grasp the upper glass section of the light and insert it into the bottom section of the light
(Fig. *1B)
Plug the power cord into an electrical outlet and ensure that the light is working properly.

Cleaning the glass

The light can be cleaned using common cleaning agents. Do not use solvents or abrasives
(e.g., scouring powder).
Prior to shipping, the functionality of each light and its components is thoroughly tested. The
manufacturer assumes no liability for the mishandling of products.
Assembly time: 10 minutes (1 person)
TECHNICAL SUPPORT
info@brokis.cz
www.brokis.cz
Light (bottom glass section including power cord with switch, diffuse
triplex bulb cover, upper glass section, rubber seal), light source – bulb
GU10, 5W – Ehmann dimmer, cotton gloves, installation manual
OFFICE
Španielova 1315/25, Praha Řepy, 16300, Czech Republic
ID 64940799, VAT CZ64940799
SHOWROOM AND FACTORY
Sídliště Janštejn 39, Horní Dubenky, 588 52,
Czech Republic
380