Advertisement
The 2.4GHz RF mouse features a dual-way transmission technology which enables the mouse and the receiver
auto-communication.
Auto-link mode
1.
Make sure the Power On/Off switch on the mouse is ON
2.
Operate the mouse, and cursor's movement is mapping mouse movement. Now the mouse and the receiver
is auto-linked successfully.
Manual-link mode
If you find the communication channel does not connect well, you can use the software communication tool to
re-connect the mouse & the receiver to reset a new channel ID. You are able to get to software on the website.
△Note
While the mouse is working, if encountering any interference, the mouse and the receiver will automatically
source out and transfer to another channel. During transferring, the cursor movement may have a second delay.
Replace the new batteries
Please replace a pair of new batteries and follow the previous instructions.
△Note
The red LED on the scroll wheel is the low batteries power indicator. It indicates that batteries inside the mouse
are needed to be replaced.
1.
Make sure you have connected the receiver correctly on the PC's USB port
2.
For the best performance, we suggest you to locate the receiver with a distance from other electric devices,
such as the computer monitor or external storage devices
3.
Make sure you have set the communications between the receiver and the mouse. Refer to the
communication section.
4.
If you find the communication channel does not work well, you may use the software connection tool to
re-connect the mouse & receiver and reset a new channel ID. You are able to get to software on the website.
5.
Some system devices might conflict with the mouse. Confirm the IRQ/address settings of these devices for
conflicts, and change the settings as required.
6.
Make sure that you are not working the mouse on glossy or reflective surfaces.
Battery use reminders
1.
Remove worn-out batteries from equipment immediately and dispose of promptly
Advertisement
