Toro TimeCutter SW 3200 Operator's Manual page 12

Key Switch
The key switch, used to start and shut off the engine,
has 3 positions: O , R
FF
Starting the Engine (page
Throttle/Choke Control
The throttle and choke controls are combined into 1
control lever. The throttle controls the engine speed
and has a continuous-variable setting from S
F (Figure 6).
AST
Blade-Control Switch (Power
Takeoff)
The blade-control switch, represented by a
power-takeoff (PTO) symbol, engages and
disengages power to the mower blades
Fuel-Presence Window
You can use the fuel window, located on the left side
of the machine, to verify the presence of fuel in the
tank (Figure 7).
Height-of-Cut Lever
Use the height-of-cut lever to lower and raise the deck
from the seated position. Moving the lever up (toward
you) raises the deck from the ground and moving the
lever down (away from you) lowers the deck toward
the ground. Adjust the height-of-cut only while the
machine is not moving
Key Choice ® Switch
This switch allows you to mow in reverse when it
is activated. To activate it, turn the switch to the O
position and release it after the PTO is engaged. To
deactivate it, disengage the power takeoff (PTO)
(Figure 7).
Operating-in-Reverse Warning
Light
The Operating-in-Reverse warning light illuminates
whenever you use the Key Choice key to deactivate
the operating-in-reverse interlock. It is a reminder that
the interlock system is deactivated. The light goes
out whenever you disengage the PTO or shut off the
engine. When the light is on, look behind you and use
extra caution when backing up.
, and S . Refer to
UN TART
20).
LOW
(Figure
(Figure 19).
Smart Park
The parking brake is activated electronically.
Engage the parking brake by 1 of the following actions:
•
Pressing the Smart Park
(Figure 6).
•
The parking brake engages automatically when
you leave the seat and the traction control pedal is
in the
NEUTRAL
to
•
The parking brake automatically engages 5 to 6
seconds after the ignition switch is turned to the
position (if it is not already engaged).
OFF
To disengage the parking brake, press the Smart Park
switch to the
position.
Attachments/Accessories
6).
A selection of Toro approved attachments and
accessories is available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
To best protect your investment and maintain optimal
performance of your Toro equipment, count on Toro
genuine parts. When it comes to reliability, Toro
delivers replacement parts designed to the exact
engineering specification of our equipment. For peace
of mind, insist on Toro genuine parts.
N
12
™ Switch
™ switch to the
position.
position with the key in the
OFF
position
ON
RUN