Table of Contents
Advertisement
the 'LOW' position and turn back (clockwise) to the Pilot ignition position. The main
burner should extinguish but the pilot should remain alight. Depress the control knob
slightly and turn back (clockwise) to turn OFF. This will extinguish the pilot.
While cooling, the ceramic fuel effects may make some crackling noises. This is quite
normal.
Note i)
If the flames go out while setting the control, repeat the full lighting
procedure. If the flames repeatedly go out have the fire serviced.
ii)
Please note. When first turned on the flames will appear predominantly
blue. The fuel effect pieces will take time to warm up. Although some glow
will be seen after approximately ten minutes, the full visual effect will only
be apparent after a somewhat longer time.
iii)
The appliance will operate to its maximum potential if the flue is primed
during the first 20 – 30 minutes of operation. To do this, simply slide the
control button to its highest setting. This will also burn off any carbon
deposits that may have formed during previous operations.
iv)
If operating the appliance for long periods it is beneficial occasionally to
change the settings. This will also help to remove any carbon deposits that
may form during operation.
Lighting with a taper.
(See figure 3).
In the unlikely event of failure of the ignition spark,
the pilot can be lit by a taper or long spill.
Turn the control knob to the 'Pilot ignition'
!
position
Insert the taper or spill between the second and
!
third left hand ceramic fuel effect pieces on the first
row
Depress the control knob. A flame should appear
!
at the pilot.
Remove the taper and keep the control depressed
!
for 5 seconds.
Release the control knob and the pilot flame
!
should remain alight. If it does not, repeat the above.
Turn the control knob to the required setting.
!
©
Baxi Heating U.K. Limited 2007.
OWNER GUIDE
Page 9
Figure 3. Lighting with a taper
(Fuel effect may differ from that
shown)
Advertisement
Table of Contents
