After Use - Hyundai HS 216 Instruction Manual

2) Smear the thermoplastic softening cream evenly to hair (it is optional when hair is in 20 %
wet condition) from the upper of the hair to the lower and then dry it naturally for 15 minutes.
3) Straightening your hair
Press the on/off switch for two seconds.
Adjusting the temperature
The unit is shipped with a setting temperature. Set the temperature by pressing buttons P3
or P4 in range 140 - 220 °C.
When the default temperature or the selected temperature is reached, Heating is displayed
by flashing numbers on LCD. After reaching setting temperatute numbers on LCD will conti-
nuously light.
After about 30 seconds, the straightener is ready for use.
4) Note:
The higher the selected temperature, the more quickly you get the desired result.
If you work with the maximum temperature, do not work on the same strands more than
once.
5) Never leave the appliance unattended when it is plugged in.
Never put the appliance on a surface that is not heat-resistant when it is heating up
and whenit is hot.
6) Comb or brush your hair so that it is disentangled and smooth.
Use a comb to divide the hair into sections. Do not put too much hair in one section.
Tip: it is better to section off the crown area and to straighten the hair underneath first.Then
straighten the top area.
7) Take a section that is not wider than 5 cm. Place it between the straightening plates and pre-
ss the handles of the appliance firmly together.
8) Slide the straightener down the length of the hair for 5 seconds, from root to hair end, wit-
hout stopping to prevent overheating.
9) Repeat this process until you have achieved the desired look.
10) Allow your hair to cool down.Do not comb or brush it before it has cooled down, as this
would ruin the hairstyle you have just created.
Ionization
Pressing the „ions" button P10 turn on ionization, which reduces static electricity.
Direct selection of the maximum temperature
Press button „° C max" P11 immediately set up the highest temperature of 220 ° C.
Locking the buttons
To avoid unwanted pressing button when using the irons, you can lock all the buttons by long
pressing the „-" P4. Fot activate all buttons press again the same button for two seconds.
Automatic shutoff:
For your safety, the straightener shuts off automatically after 30 minutes.
Lock system
For better storage close heating plates and lock it by turning button P9.

AFTER USE

• Press the on/off switch for two seconds. The straightener shuts off. Pull out the power plug
and store it after strightener cooled.
• Place the straightener on a non-combustible surface.
ENG - 19
ENG