DèLonghi ECAM35 55 Series Instructions For Use Manual page 22

Ground too fine
Adjust mill
Less coffee
Insert water spout
Insert milk container
Insert infuser assembly
Water circuit empty
Fill water circuit
Hot water
Confirm?
Press OK to CLEAN
Set dial to CLEAN
ESC to cancel
Turn froth adjustment dial
Descale
ESC to cancel
OK to descale
(∼45 minutes)
Replace filter
ESC to cancel
OK to replace
General alarm
The grinding is too fine and the coffee is deliv-
ered too slowly or not at all.
If the water softener filter (C4) is present, an
air bubble may have been released inside the
circuit, obstructing delivery.
Too much coffee has been used.
The hot water spout (C6) is not inserted or is
inserted incorrectly.
The milk container (D) is not inserted correctly. Insert the milk container as far as it will go (fig.
The infuser (A20) has not been replaced after
cleaning.
The water circuit is empty.
The milk container (D) has been inserted with
the froth adjustment dial (D1) in the "CLEAN"
position.
Milk has been delivered recently and the tubes
inside the milk container (D) must be cleaned.
The milk container (D) has been inserted with
the froth adjustment dial (D1) in the "CLEAN"
position.
The machine must be descaled.
The water softener filter (C4) is exhausted.
The inside of the appliance is very dirty.
Repeat coffee delivery and turn the grinding
adjustment dial (A5) (fig. 7) one click clockwise
towards 7 while the coffee mill is in operation.
If after making at least 2 coffees delivery is
still too slow, repeat the correction procedure,
turning the grinding adjustment dial another
click until delivery is correct (see section "10.1
Adjusting the coffee mill". If the problem per-
sists, make sure the water tank (A17) is fully
inserted.
Insert the hot water spout (C6) in the appli-
ance and deliver a little water until the flow
becomes regular.
Select a lighter taste by pressing
reduce the quantity of pre-ground coffee.
Fully insert the hot water spout (fig. 4).
16).
Insert the infuser as described in section "14.9
Cleaning the infuser".
Press OK (B3) to deliver water from the spout
(C6) until it flows out normally. If the problem
persists, make sure the water tank (A17) is fully
inserted.
To proceed with the CLEAN function press OK
or turn the froth adjustment dial to another
position.
Turn the froth adjustment dial (D1) to CLEAN
(fig. 19).
Turn the froth adjustment dial to one of the
milk froth positions.
The descaling procedure described in section
"15. Descaling" needs to be performed.
Replace the filter or remove it as described in
section "17. Water softener filter".
Clean the inside of the appliance thoroughly,
as described in section "14. Cleaning". If the
message is still displayed after cleaning, con-
tact a service centre.
22
(B7) or