Transportation - Bosch WAT286H9IN Instruction Manual And Installation Instructions

Run the program without laundry:
Switch on the appliance.
1.
Close the door (do not load any
2.
laundry).
Set the Drum Clean 90 °C program.
3.
Open the detergent drawer.
4.
Pour approx. 1 litre of water into the
5.
manual dosing compartment.
Pour all-purpose detergent into the
6.
manual dosing compartment.
To prevent foaming, only use
Note:
half the amount of detergent
recommended by the detergent
manufacturer.Do not use detergents
intended for woollens or delicates.
Close the detergent drawer.
7.
Start the program.
8.
Switch off the appliance once the
9.
program has finished.
Your washing machine is now ready to
use.

Transportation

E.g. when moving house
Preparatory work:
Turn off the tap.
1.
Release the water pressure in the
2.
supply hose: ~ "Filter in the water
supply blocked" on page 46
Disconnect the washing machine
3.
from the mains power supply.
Drain the remaining water: ~ "The
4.
drain pump is blocked, emergency
draining" on page 45
Detach the hoses.
5.
Empty the dispensers. ~ Page 41
6.
Caution!
Risk of damage to the appliance
caused by detergent/fabric softener
leaking from the dispensers
Leaking detergent/fabric softener
can prevent the appliance from
working correctly, e.g. due to
damage to the electronics.
Empty the dispensers before
transporting the appliance.
Positioning and connecting
Fitting the transportation securing
means:
Remove the covers and keep them
1.
in a safe place.
If required, use a screwdriver.
Insert all four sleeves.
2.
Clip the mains cable securely in the
holders. Insert the transportation
securing bolts and tighten them with
a wrench (WAF 13).
Before switching on the appliance
again:
Notes
The transit securing devices must
■
be removed. ~ Page 14
To prevent unused detergent from
■
flowing straight into the drain during
the next wash, pour approx. 1 litre of
water into the manual dosing
compartment, select the Drain/
Empty program and start this
program.
en
19