Table of Contents
Advertisement
Faults
Foam is leaking from the
detergent drawer.
Repeated, intensive foam-
ing.
Detergent/fabric softener
drips off the seal and col-
lects on the door or in the
seal fold.
Washing results not satis-
factory.
The drum briefly jerks or
judders after the program
has started.
The water is not being
pumped out.
Water is not visible in the
drum.
Spin results not satisfac-
tory.
Laundry is wet/too damp.
Drum starts rotating
briefly several times.
The program is taking
longer than usual.
The duration of the pro-
gram changes during the
wash cycle.
Cause/remedy
Automatic dosing: i-DOS Check the dosage settings and, if required, reduce
■
the detergent dosage. ~ Page 39
If necessary, use a different liquid detergent/fabric softener.
Manual dosing: Have you used too much detergent? Use less detergent for
■
the next wash cycle.
Immediate action: Mix one tablespoon of fabric softener with 1/2 litre of
■
water and pour it into the manual dosing compartment (not suitable for out-
door clothing, sportswear or items stuffed with down).
Automatic dosing: i-DOS Check the dosage settings and, if required, reduce
■
the detergent dosage. ~ Page 39
If necessary, use a different liquid detergent/fabric softener.
Manual dosing: Have you used too much detergent? Add less detergent the
■
next time you run a wash cycle with the same load.
There is too much detergent/fabric softener in the dispensers. Do not fill the
dispensers above the max. mark.
i-DOS Check the dosage settings and, if required, increase the detergent
■
dosage. ~ Page 39
Use a different liquid detergent.
■
Not a fault – the internal motor test may cause the drum to jerk or judder briefly
when the wash program starts.
Is $ selected (Rinse Stop = no final spin)? ~ Page 31
■
Clean the drain pump. ~ Page 45
■
Clean the drain pipe and/or the drain hose.
■
Not a fault – the water is below the visible area.
Not a fault – the unbalanced load detection system has interrupted the spin
■
cycle because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum.
Is Easy-Iron selected? ~ Page 27
■
Is the selected speed too low?
■
Not a fault – the unbalanced load detection system is eliminating an imbalance.
Not a fault – the unbalanced load detection system is eliminating an imbal-
■
ance by repeatedly redistributing the laundry.
Not a fault – the foam detection system is active; this adds an additional
■
rinse cycle.
Not a fault – the program sequence is optimised for the specific washing pro-
cess. This may change the program duration shown on the display panel.
Faults and what to do about them.
en
51
Advertisement
Table of Contents
