Garland TEXEL 517 GB Instruction Manual page 38

English
Raise the handle (8) of the retaining molding to the
vertical position.
Place the screw (8) by applying a slight pressure
of the spring (5) in the threaded hole of the handle
support (7).
Rotate the handle (8) clockwise until the clamping
strip (6) lines up with the grooves and touches the
handle bracket (7). Put the handle (8) back down.
Transport position
Loosen the grip (8) and unscrew until the handlebar
(2) can be turned. Turn 90º, lower the handlebar (2),
and then turn the grip (8) firmly.
6.2.2. MOUNTING THE GUARD AND THE BOWL
Use the four screws (2) M5x26 supplied with the
machine to fix the protection device (1) to the bracket
(3)
The skirt of the protector must not be worn when
working with the cutting disk.
38/156