Garland TEXEL 517 GB Instruction Manual page 37

6. START UP INSTRUCTIONS
6.1.LIST OF MATERIALS
This machine includes the following elements that you
will find inside the box:
• Machine.
• Protector.
• Handlebar.
• Tools.
• Cutting accessories.
• Harness.
• Instruction manual.
Ensure that all elements listed above are included with
the machine. Thanks to the quality control checks at
the factory it is highly unlikely that any elements will
be missing. If you were to find any element missing,
do not use the machine until the defect has been
repaired or the machine is complete.
Using the machine with defective parts or without all
the elements can cause severe personal damages.
6.2. MOUNTING THE MACHINE
6.2.1. MOUNTING THE HANDLEBAR
Do not rotate
the control
lever (1)
between
unpacking and
mounting on
the handlebar.
position of the clamping molds on the handlebar until
the control lever is mounted.
spring in the bracket and fix it to the handle bracket
on the machine. Use the spring (5) with the machine.
Push the spring (5) into the bracket molding from the
bottom (6).
Place the clamping molding (4) with the handlebar (2)
on the handle holder (7). Do not turn the handlebar in
the clamping molding.
37/156
English
The machine is
shipped with the
clamping molds (4)
mounted on the
handlebar (2). Do
not change the
To mount
the swivel
handle
bracket it
is
necessary
to place a