Table of Contents
Advertisement
9.
Slide the optical drive through the front bezel (1) all the way into the bay so that the green latch locks
onto the chassis frame (2).
10.
Connect the power cable (1) and data cable (2) to the rear of the optical drive.
11.
If installing a new drive, connect the opposite end of the data cable to one of the light blue SATA
connectors (labeled SATA1 and SATA2) on the system board.
12.
Replace the front bezel if it was removed.
13.
Replace the computer access panel.
Removing and installing drives
25
Advertisement
Table of Contents
