Toro 68037G Operator's Manual page 48

The steering is not working properly.
The steering needs to be calibrated.
The steering linkage needs to be adjusted.
The hopper is not functioning properly.
The hydraulic fluid is low.
There is air in the hydraulic system.
The sensor is not working.
The switch is loose or disconnected.
The hydraulic system is damaged.
Troubleshooting: Battery Storage Requirements
Possible Cause
Possible Cause
Use the display to calibrate the steering
system.
Check the steering linkage assembly for
loose or missing hardware.
Check the hydraulic fluid.
Bleed the air out of the hydraulic system.
1. Adjust the sensor to 8 mm (3/4 inch)
above the mounting bracket.
2. Check if the sensor has gone bad.
1. Check the electric connections.
2. The switch has gone bad. Contact your
Authorized Service Dealer.
Contact your Authorized Service Dealer.
Page 7–2
Corrective Action
Corrective Action
3465-683 A