Black & Decker BEV BCHB101 Instruction Manual page 8

English
Power Supply Cleaning Instructions

WARNING: Shock hazard. Disconnect the power
supply from the AC outlet before cleaning. Dirt and
grease may be removed from the exterior of the power
supply using a cloth or soft non‑metallic brush. Do not
use water or any cleaning solutions.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from power
source and remove the battery pack before
making any adjustments or removing/installing
attachments or accessories. An accidental start‑up
can cause injury.
Installing Bottles (Fig. C)

WARNING: Only use water in the supplied water
bottle. Use of other liquids or substances in the water
bottle may result in damage to the appliance.

CAUTION: Avoid spills while installing bottles.
nOTE: It is recommended to use 750 ml bottles or smaller
to ensure all bottles sit on the bottle platform
hanging off the platform.
nOTE: Bottles must fit between the bottle platform and the
top of the cocktail maker while standing.
1. Slide a straw 13 into a bottle so the straw tip
bottom of the bottle.
2. Slide the bottle stopper
fully in the top of the bottle.
3. Ensure the straw lock
4. Align the straw plug notch
5. Slide the straw plug 17
allowing the bottle to sit freely in its designated space.
Ensure the straw plug is fully seated in the slot
6. To lock it into place, push the straw lock down until it
clicks. Ensure the lever is fully down.
7. Repeat for all bottles.
6
12 without
14
19 down the straw until it sits
15 is up.
18 with the straw slot
all the way into the straw slot,
sits on the
12
iMPORTAnT: Bottles must be placed in their designated space
16 .
to ensure the correct drink is dispensed. Names of the liquids are
located in each spot, indicating the appropriate liquid.
iMPORTAnT: The following are the only liquids that should
be used with the appliance.
• Water
• Gin
• Rum
• Vodka
• Tequila
• Whiskey
Removing Bottles (Fig. D)

CAUTION: Avoid spills while removing bottles.
1. Lift the straw lock
2. Slide the straw plug
3. Pull the bottle stopper
the straw
nOTE: If the cocktail maker pauses for an empty bottle and you
press mix without replacing the bottle, it will skip to the next
bottle in the recipe. If that bottle is empty, it will pause again.
Refer to the PAUSE MODE section for more information.
Fig. C
15 17
19
16
13
14
12
Rum
Rhum
Ron
Gin
Ginebra
Tequila
15 .
17 and bottle off the cocktail maker.
19 out of the bottle and remove
13 .
18
Water
Eau
Agua
Vodka
Whiskey
Whisky