Dantherm MASTER CF 75 User And Maintenance Manual page 22

REQUIRED TO COMPLETELY ISOLATE
en
THE HEATER FROM THE MAINS POW-
it
ER NETWORK (Fig. 24).
de
es
fr ►►13.CONNECTING THE RE-
MOTE ROOM THERMOSTAT
nl
••IMPORTANT: When the heater is con-
pt
trolled by a remote room thermostat, the
heater can switch back on at any time
da
when the temperature drops below the
fi
set threshold.
no
To connect the remote room thermostat,
sv
remove the plug connected to the heater
pl
and connect the remote room thermostat
(optional item) (Fig. 26).
ru
cs
hu
►►14.CLEANING THE HEATER
sl
••IMPORTANT: Do not conduct any clean-
tr
ing unless the heater has first been turned
off (Fig. 23) and disconnected from the
hr
mains (Fig. 24).
lt
The only possible cleaning steps carried
lv
out by the user are associated with the
et
heater's outer surfaces. Only use a damp,
ro non-abrasive cloth to clean the outer
surface of the heater (do not use sponges
sk
with aggressive products or powder
bg
detergents). After cleaning the surface,
dry it thoroughly.
uk
CAUTION: IF THE HEATER NEEDS
bs
MORE THOROUGH
CONTACT
el
TECHNICAL SUPPORT CENTRE.
zh
CLEANING,
THE AUTHORISED
►►15.PUTTING THE HEATER
OUT OF SERVICE
If the heater is not used on the medium/
long term, disconnected it from the elec-
tricity mains (Fig. 24) and protect it from
humidity and dust. When the heater is
used again, check the condition of the
power supply cable. If in doubt regard-
ing its state, contact the technical sup-
port centre. In any case, have the heater
checked once a year.
►►16.OPTIONAL ITEMS
•Outdoor assembly kit (recirculation or air
suction mode, depending on the external
damper position).
•Remote room thermostat.
•Air outlet opening diffuser.