ETNA KCV282N Series Instructions For Use Manual page 45

INSTALLATION AND CONNECTION
11. Slide the bottom door back on to the lower hinge, making sure that the lower hinge pin fits
into the lower hole of the door.
12. Place the middle hinge in the door. Pay attention to the positioning of any adjustment
washers.
13. Position the door and tighten the screws of the middle hinge.
14. Slide the top door back on to the middle hinge, making sure that the middle hinge pin fits
into the lower hole of the door.
15. Fit the upper hinge on the opposite side with the screws.
16. Place the cover plates (use the left hinge cover plate that was provided).
17. Check that the door is aligned horizontally and vertically and that the seals are closed on all
sides before finally tightening the bottom hinge. Level the appliance with the adjustable feet.
EN 17