MSI K9N SLI V2 Series Manual page 49

On-Chip IDE Controller
This item allows you to enable/ disable IDE Controller.
PCI IDE BusMaster
This item allows you to enable/ disable BIOS to use PCI busmastering for read-
ing/ writing to IDE drives.
On-Chip SATA Controller
This item allows users to enable or disable the SATA controller.
RAID mode
Select [AHCI] to enable the AHCI (Advanced Host Controller Interface) function.
Select [IDE] to configure the SATA device as IDE device and without AHCI function.
Setting this option to [RAID] activates the following fields, and use the following
fields to enable RAID for SATA hard disks.
SATA 1/2/3/4
These items allow you to enable RAID for SATA 1/2/3/4.
I/O Device
Press <Enter> to enter the sub-menu and the following screen appears:
COM Port 1
Select an address and corresponding interrupt for the first serial port.
Parallel Port
There is a built-in parallel port on the on-board Super I/O chipset that provides
Standard, ECP, and EPP features. It has the following options:
[Disabled]
[3BC]
[278]
[378]
Parallel Port M ode
[Normal]
[EPP]
[ECP]
[Bi-Directional] Extended Capability Port + Enhanced Parallel Port
To operate the onboard parallel port as Standard Parallel Port only, choose
[Normal]. To operate the onboard parallel port in the EPP mode simultaneously,
choose [EPP]. By choosing [ECP], the onboard parallel port will operate in ECP
mode only. Choosing [Bi-Direction] will allow the onboard parallel port to support
both the ECP and EPP modes simultaneously.
Line Printer port 0
Line Printer port 2
Line Printer port 1
Stardand Parallel Port
Enhanced Parallel Port
Extended Capability Port
BIOS Setup
3-13