Table of Contents
Advertisement
en Troubleshooting
Fault
Tableware is not dry.
Plastic tableware is not dry.
Cutlery is not dry.
Appliance interior still wet
after wash cycle.
Remnants of food on table-
ware.
38
Cause
The combined detergent
used has a poor drying per-
formance.
Extra Dry not activated to im-
prove drying performance.
Tableware removed too
early or drying process not
yet ended.
Rinse aid used has a limited
drying performance.
Not a fault. As plastic does
not store heat so well, it also
does not dry as well.
Cutlery not arranged prop-
erly in the cutlery basket or
cutlery drawer.
Not a fault. The condensa-
tion drying principle causes
water droplets in the tub –
they are indeed desirable
here. The moisture in the air
condenses on the inside
walls, runs off and is
pumped out.
Tableware was placed too
close together.
troubleshooting
Use rinse aid to improve drying per-
1.
formance.
Use a different combined detergent
2.
with a better drying performance.
Activate Extra Dry.
▶
Wait until the programme ends.
1.
Only remove tableware 30 minutes
2.
after the programme has ended.
Use a name-brand rinse aid.
▶
Eco products may have limited ef-
fectiveness.
No remedial action possible.
▶
Arrange the cutlery properly.
1.
→ "Arrange tableware", Page 28
Arrange cutlery individually where
2.
possible.
Avoid points of contact.
3.
No action required.
Arrange tableware with sufficient
1.
space in between.
The spray jets must reach the sur-
faces of the tableware.
Avoid points of contact.
2.
Advertisement
Table of Contents
