Sharp XE-A106 Quick Start Manual

XE-A106 Quick Start Guide
The following describes how to get your cash register ready to operate. Follow these steps when you use the cash register for the first time.
1

Initializing the Cash Register

To ensure the cash register operates properly,
initialize it using the following procedure:
1. With the power cable unplugged, insert the
supplied mode key into the mode switch and turn
it to the REG position.
VOID
2. Insert the plug of the power cable into the AC
outlet.
IMPORTANT
This operation must be performed without
batteries loaded.
The buzzer will sound three times.
3. Now the cash register has been initialized. The
register display will show "0.00" with " " .
The following are supplied with your cash register.
1 paper roll 1 Quick Start Guide (English)
1 mode key 1 Quick Start Guide (Spanish)
1 drawer lock key
1 ink roller (pre-installed)
1 instruction manual (English)
1 take-up spool
1 instruction manual (Spanish)
1 paper holding plate
1 mounting bracket
2

Installing Batteries

Install batteries for back-up of sales data and
programmed contents.
1.Push the printer cover
forward and detach it.
REG
X/Flash
OFF
Z/PGM
2.Open the battery
cover next to the
paper roll cradle.
3.Insert three new "AA"
batteries. (Batteries
are not supplied with
the cash register.)
4. When the batteries are properly installed, " " on
the display will disappear.
Close the battery cover.
IMPORTANT
Improper use of batteries may damage the cash
register. Please take the following precautions.
Be sure that the positive (+) and negative (-) poles
•
of each battery are oriented properly.
Never mix batteries of different types.
•
Never mix old batteries and new ones.
•
Please read the instruction manual for other
battery handling precautions.
View from rear
View from rear
3

Installing a Paper Roll

1.Place a paper roll in the
paper roll cradle so that the
paper unrolls from the
bottom.
NOTE
Before placing a new paper roll in the paper roll
cradle, cut off the pasted (taped) part of the paper
and confirm that the cut end of the paper is straight.
2.Insert the paper straight
into the paper inlet, and
press the key.
The inserted end comes
out at the printing area.
3. (For journal printing)
Insert the top end of the paper into the slit in
the take-up spool shaft and fold the inserted
end toward you.
Wind the paper two or three turns.
Mount the supplied paper holding plate onto
the take-up spool.
Put the spool shaft in the larger hole of the paper holding
plate and push the plate in the direction of the arrow.
Place the take-up spool on the bearing.
4.Attach the printer cover.
(For receipt printing, step 3 should be omitted.)
English