sparkfun ZX Distance and Gesture Sensor Hook-Up Manual page 16

• I2C_Gesture_Demo – Poll the sensor over I C to see if any gestures
have occurred.
• I2C_Gesture_Interrupt – The DR pin will go from low to high when a
gesture is detected. This example reads the gesture over I2C and
tells the sensor to clear DR.
• I2C_ZX_Demo – Poll the sensor periodically over I C for Z- and X-
axis data.
• I2C_ZX_Interrupt – The ZX Sensor will throw DR high whenever
valid ZX data is ready.
• UART_Gesture_Demo – NOTE: Gestures over UART are not
supported at this time. This demo is a placeholder for the time being.
• UART_ZX_Demo – Read Z- and X- axis data from a software serial
port and display them on the Serial Monitor.
Resources
Here are some additional resources to help you with the ZX Sensor:
• ZX Sensor Datasheet
• Using the ZX Sensor with Arduino
• ZX Sensor Schematic
• ZX Sensor GitHub Repository
• ZX Sensor I2C Register Map
Other Tutorials
What will you make with the ZX Sensor? If you need some inspiration,
check out these related tutorials:
Connecting Arduino to
Processing
Send serial data from Arduino to
Processing and back - even at the
same time!
RGB Panel Hookup Guide
Make bright, colorful displays using
the 32x32 and 32x16 RGB LED
panels. This hookup guide shows
how to hook up these panels and
control them with an Arduino.
https://learn.sparkfun.com/tutorials/zx-distance-and-gesture-sensor-smd-hookup-guide?_ga...
2
2
Serial Graphic LCD Hookup
Learn how to use the Serial Graphic
LCD.
APDS-9960 RGB and
Gesture Sensor Hookup
Guide
Getting started guide for the Avago
APDS-9960 color, proximity, and
gesture sensor.
Page 16 of 16
6/6/2017