Advertisement
This type of transducer may be used with a thru-hull transducer which
reads depth only. The speed/temperature transducer is attached to the
transom of the boat. Detailed instructions for this installation will be
included with the transducer. The cable for this transducer uses a "Y"
connector. See the notes on "Installing the Transducer Cable."
You may mount the display unit on any flat surface using the bracket
supplied. See Fig. 2-8. (There is also an optional kit which allows you to
flush-mount the display in a flat panel or dashboard). Follow these
instructions if you are using the standard mounting bracket:
1.
The "LCD" type display used on this unit is easier to see from certain
angles. Before selecting a permanent mounting location, make
temporary power connections and turn on the unit. This will allow you
to test the visibility of the display from several different angles.
2.
Remove the display unit from the bracket by pressing on the large
button in the center of the bracket. See Fig. 2-8.
To release the
display from
the base,
press here.
The display can
be turned from
side to side.
The angle of
the display
can be changed.
Installation
on Bracket
13
Advertisement
