Table of Contents
Advertisement
12. Note: If the treadmill is assembled on a
smooth surface, it may roll forward during
this step.
Raise the Frame (74) to the position shown.
IMPORTANT: Do not raise the Frame past the
vertical position. Have a second person hold
the Frame until step 14 is completed.
Remove the two 5/16" x 1 1/4" Screws (26)
from the Latch Crossbar (76). Note: The Latch
Crossbar is not preattached to the treadmill.
Next, orient the Latch Crossbar (76) as shown.
Make sure that the "This side toward belt"
sticker (H) is facing the treadmill. Attach
the Latch Crossbar to the brackets (I) on the
Frame (74) with the two 5/16" x 1 1/4" Screws
(26) that you just removed and two 5/16" Star
Washers (7).
13. Remove the 5/16" Nut (49) and the 5/16" x 1 3/4"
Bolt (25) from the bracket on the Base (118).
Next, orient the Storage Latch (75) as shown.
Attach the lower end of the Storage Latch
(75) to the bracket on the Base (118) with the
5/16" x 1 3/4" Bolt (25) and the 5/16" Nut (49).
Then, raise the Storage Latch (75) to a vertical
position, and remove the tie (J).
12
I
7
26
13
J
49
14
76
H
I
7
74
26
75
118
25
Advertisement
Table of Contents
