Cleaning, Maintenance And Ordering Of Spare Parts; Replacing The Power Cable; Disposal And Recycling - EINHELL bavaria BJS 750 L Operating Instructions Manual

Anleitung_BJS_750_L_SPK1:_
6.6 Sawing out sections (Fig. 9)
Drill a 10 mm hole in the section you wish to saw out.
Insert the saw blade into this hole and start to saw out
the required section.
6.7 Making miter cuts
Set the angle on the soleplate (see section 5.3).
Observe the instructions in section 6.5.
Cut as shown in Figure 10.
6.8 Laser function (Fig. 11)
You can switch the laser ON and OFF with the
switch (13).
The laser directs a beam onto the workpiece.
With the laser function you can make cuts of the
highest precision.
The laser beam can be effected by deposits of
dust and chips. The emission aperture of the
laser beam must therefore be cleaned after each
use.
Always switch off the laser when not in use.
Replacing the battery
Ensure that the laser is switched off. Remove the
battery compartment cover (a). Remove the old
batteries and replace with new ones (2 x 1.5 AAA).
Check that the battery terminals are positioned
correctly when inserting the new batteries. Close the
battery compartment again.

7. Replacing the power cable

If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
15.09.2008 13:56 Uhr Seite 15
8. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
8.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

9. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
GB
15