Installing The Antenna Cover; Removing The System Board - Dell Precision 5530 Service Manual

Installing the antenna cover

1 Replace the antenna cover on the display assembly.
2 Turn the display hinges to the normal position.
3 Install the:
a Display assembly
b WLAN card
c Battery
d Base cover
4 Follow the procedures in
System board

Removing the System Board

1 Follow the procedures in
2 Remove the:
a base cover
b battery
c fans
d heatsink assembly
e WLAN
f hard drive (optional)
g keyboard
h SSD
i memory modules
NOTE: Your computer's Service Tag is located under the system badge flap. You must enter the Service Tag in the BIOS
after you replace the system board.
NOTE: Before disconnecting the cables from the system board, note the location of the connectors so that you can re-
connect them correctly after you replace the system board.
3 To remove the system board:
a Lift the latch and disconnect the touchpad cable [1].
b Lift the latch and disconnect the keyboard controller board cable [2].
c Disconnect the power connector port cable from the system board [3].
d Disconnect the speaker cable from the connector from the system board [4].
e Peel the adhesive tape and lift the latch to remove the fingerprint cable [5]
f Lift the plastic lever and disconnect the display touchscreen cable [6]
g Peel the adhesive tape to release the touch screen cable.
38 Disassembly and reassembly
After Working Inside Your Computer.
Before Working Inside Your Computer.