Installing the display back cover and antenna assembly
CAUTION:
The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the display back cover and antenna assembly and provide a visual representation of
the installation procedure.
Figure 52. Installing the display back cover and antenna assembly
Steps
Place the display back cover and antenna assembly on a flat surface.
Next steps
1. Install the
display
cable.
2. Install the
camera
module.
3. Install the
display
panel.
4. Install the
display
hinges.
5. Install the
display
bezel.
6. Install the
display
assembly.
7. Install the
wireless
card.
8. Install the
base
cover.
9. Follow the procedure in
After working inside your
computer.
Removing and installing Field Replaceable Units (FRUs)
77