Lab.gruppen FA602 Quick Start Manual page 6

Controls
(1) Input LEDs - Light green for signal and red
for limit/fault.
(2) POWER LED - Lights blue for power on and
yellow for sleep mode.
(3) Mains connector – Connect the IEC cable to
a mains outlet.
(4) Config switches – Configure the output
channel for the connected load type.
See 'Getting Started' section for details.
(5) Output – Connect your speaker(s).
(6) Remote – Allows the connection of an
external volume control module per channel.
CRC-V available as a separate accessory.
(7) Euroblock input – Accepts 3-pin Euroblock
connectors for balanced line-level sources.
Input A is routed to Output A, Input B is routed
to Output B, etc.
(8) Input Level switch - Select + 4 for line-level
sources and -10 for mic-level sources.
(9) Gain - Adjust the gain level for each input.
If the respective front panel LED lights red,
reduce the gain to avoid clipping.
11
Quick Start Guide