Notes On The Documentation; Symbols Used; Observe Other Applicable Documents; Storing Documents - Glow-worm Smart Wiring Center 2 Installation And Servicing

INTRODUCTION
1

notes on the documentation

1.1

symbols used

The symbols used in the text are explained below:
symbol explanation
i
Symbol that denotes useful tips and information
∙
Symbol for a required action
The warning notes are classified in accordance with the severity
of the possible danger using the following warning signs and
signal words.
Warning symbol signal word
a
Danger
e
Danger
a
Warning
b
Caution
1.2

observe other applicable documents

∙ Observe absolutely all operating and installation instructions
enclosed with the product, for the various parts and
components of the system.
1.3

storing documents

∙ Pass these instructions and all other applicable documents to
the system user.
The system user should retain these instructions so that they are
available when required.
1.4

Validity of the instructions

These instructions apply exclusively to:
Product
Smart Wiring Center 2
EN
- 2 -
explanation
Immediate danger to life or risk of
severe personal injury.
Risk of death from electric shock.
Risk of minor personal injury.
Risk of material or environmental
damage.
liste type
article number
0020135101
2

safety

All electrical work performed on the equipment must be carried
out by a qualified engineer or Glow-worm Group Service engineer.
This equipment must only be installed by a qualified engineer, to
ensure that the applicable regulations and rules are adhered to.
When work on the appliance is completed, perform an operational
test and check for safety in accordance with BS EN 7671.
2.1

General safety advices

∙ Before to read this chapter, also read the general safety advice
of the operating instructions.
2.1.1 Danger to life by electric shock
Touching live connections can cause serious personal injury.
∙ Before carrying out any work on the product, switch off the
power supply.
∙ Secure the power supply against being switched on again.
2.1.2 Danger to life by escaping gas
Incorrect installation can cause leakages and explosion.
∙ Make sure there are no stresses in the gas line.
∙ Correctly position the seals.
∙ Observe the legal directives and the local regulations for gas
supply companies.
2.1.3 Danger to life by escaping flue gases due to
unlocked openings
Flue gases can escape through openings in the flue pipe.
Inspection chambers in the flue gas pipe can be opened.
∙ Open inspection chambers only if you are a competent person.
∙ Close all inspection chambers before start-up.
2.1.4 Danger to life due to missing or not properly
working safety devices
Missing safety devices can cause life-threatening scalding and
other injuries, for example by burst pipes.
The information contained in this document do not show all
schemes required for a professional installation of safety devices.
∙ Install the necessary safety devices in the system.
∙ Inform the user about the function and location of safety
devices.
∙ Observe the relevant national and international laws,
standards and guidelines.
0020140826_00 - 08/12 - Glow-worm