Table of Contents
Advertisement
Leveling the Mower Deck
1.
Set the anti-scalp rollers to the top holes or
remove them completely for this procedure; refer
to
Adjusting the Anti-Scalp Rollers (page
2.
Set the height-of-cut lever to the 76 mm (3 inch)
position; refer to
(page
24).
3.
Place 2 blocks, each having a thickness of 6.6
cm (2-5/8 inches), under each side of the front
edge of the deck but not under the anti-scalp
roller brackets
(Figure
4.
Place 2 blocks, each having a thickness of 7.3
cm (2-7/8 inches), under the rear edge of the
cutting deck skirt, 1 on each side of the cutting
deck
(Figure
64).
Figure 64
1. Wood block—6.6 cm
(2-5/8 inches) thick
2. Wood block—7.3 cm
(2-7/8 inches) thick
5.
Loosen the adjustment bolts on all 4 corners so
that the deck is sitting securely on all 4 blocks
(Figure
65).
Adjusting the Height of Cut
64).
3. Front edge
24).
1. Deck-lift arm
2. Chain
6.
Ensure that there is tension on all 4 chains
(Figure
7.
Tighten the 4 adjustment bolts
8.
Ensure that the blocks fit snugly under the deck
skirt and that all bolts are tight.
g297501
9.
Verify that the deck is level by checking the
side-to-side level and front-to-rear blade slope;
repeat the deck leveling procedure if necessary.
44
Figure 65
3. Hook
4. Adjustment bolt
65).
g297515
(Figure
65).
Advertisement
Table of Contents
