Servicing The Spark Plug - Toro Titan MR 6000 Operator's Manual

Figure 38
6. Dispose of the used oil at a recycling center.
Changing the Engine-Oil Filter
Service Interval: Every 200 hours—Change the
engine-oil filter (more often in dirty
or dusty conditions).
1. Drain the oil from the engine; refer to
the Engine Oil (page
2. Change the engine-oil filter
Changing
32).
(Figure 39).
g235264
Note:
Ensure that the oil-filter gasket touches
the engine, and then turn the oil filter an extra
3/4 turn.
3. Fill the crankcase with the proper type of new
oil (Figure

Servicing the Spark Plug

Service Interval: Every 100 hours
Ensure that the air gap between the center and side
electrodes is correct before installing the spark plug.
Use a spark plug wrench for removing and installing
the spark plug and a gapping tool or feeler gauge to
check and adjust the air gap. Install a new spark plug
if necessary.
Type of Spark Plug: NGK
Air Gap: 0.75 mm (0.03 inch)
Removing the Spark Plug
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
33
Figure 39
35).
® BPR4ES
g027477