Sharp HT-SB200 Operation Manual page 12

Speaker preparation (continued)
HT-SB200
4
Screw the wall mount angle to the wall as shown in the
illustration. (Total screw is 8 pieces)
Wall mount angle
Wall surface
Wall surface
Note:
Make sure all screws are fully tighten. (screws are not supplied)
12
Wall mount angle
Wall surface
(screws x 4)
Wall mount angle
■ Installing the speaker
1
Align the wall mount slot at the speaker to the wall
mount angle.
2
Slot the speaker into the wall mount angle.
3
Fix them securely.
(screws x 4)
Wall surface