To mount the speaker on the wall
Caution:
●
Be very careful to prevent the speaker [3.86 lbs. (1.75 kg)]
from falling when mounting on the wall.
●
Before mounting, check the wall strength. (Do not put on the
veneer plaster or whitewashed wall. The speaker may fall.) If
unsure, consult a qualified service technician.
●
Mounting screws are not supplied. Use appropriate ones.
●
Check all wall mount angle screws for looseness.
●
Select a good location. If not, accidents may occur or the
speaker may get damaged.
●
SHARP is not responsible for accidents resulting from
improper installation.
■ Driving screws
SHARP designed the speakers so you may hang them on the
wall. Use proper screws (not supplied). See below for size and
type.
1/8" (3.2 mm)
3/16"
(5 mm)
Min. 7/8" (22 mm)
3/8" (9 mm)
■ Wall mount angle fixed to the wall
(Horizontal position)
1
Fix the pattern paper to the wall in horizontal position
as below.
509 mm
Wall surface
44 mm
29 mm
2
Make a hole on the wall following the screw point
marks on the pattern paper by using a drill.
1-1/4" (32 mm)
3/8" (8-9 mm)
Wall surface
3
Fix a wall mount plug into the hole using a hammer,
until it is flush with the wall surface.
1-1/4" (32 mm)
3/8" (8-9 mm)
Wall surface
44 mm
29 mm
Pattern paper
Continued to the next page
HT-SB200
11