Dubbing From Tape To Tape - Sharp CD-BA250 Operation Manual

Dubbing from Tape to Tape

You can record from TAPE 1 to TAPE 2.
For recording, use only normal tapes. Do not use metal or CrO tapes.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette into the TAPE 1 cassette compart-
ment. Insert a blank tape into the TAPE 2 cassette compartment.
It is recommended that the recording tape is the same length as the master tape.
3
Press the TAPE (1 2) button until "TAPE 1" appears on the dis-
play.
4
Press the REC PAUSE ( ) button.
Recording will be paused.
5
Press the / button on the main unit or the TAPE 2
the remote control to start dubbing.
To stop dubbing:
Press the (TAPE ) button.
TAPE 1 and TAPE 2 will simultaneously stop.
„ Erasing recorded tapes
1 Load the tape to be erased into the TAPE 2 cassette compartment with the side to
be erased facing toward you.
2 Press the TAPE (1 2) button until "TAPE 2" appears on the display.
3 Press the REC PAUSE ( ) button.
4 Press the / button on the main unit or the TAPE 2
trol to start erasing.
Note:
Make sure that the TAPE 1 is not in use.
00/12/4 CD-BA250(U)3.fm
button on
button on the remote con-
25