Harman Kardon HKTS 30 User Manual page 8

Front Left
Speaker Cable
(White Bands)
FRONT
+ –
+ – + –
Receiver
Left
Surround
Connecting the Subwoofer to a Receiver or Preamp/Processor With a Dedicated Subwoofer Output
Use this installation method for receivers and preamp/processors that have a dedicated
subwoofer output with low-pass filtering (also called bass management). If the dedicated
subwoofer output does not have low-pass filtering, follow the instructions in Connecting
the Subwoofer to a Receiver or Preamp/Processor With Line Outputs, on page 9.
Use the LFE (purple) connector of the supplied combination LFE and trigger cable to
connect the HKTS200SUB's Line-Level LFE In Jack
(or LFE output) of your receiver or preamp/processor.
Left Front
Speaker Cable
(Green Bands)
– +
SURROUND CENTER
+ –
RIGHT
LEFT
SUB
LFE OUT
Surround Left
Speaker Cable
(Blue Bands)
– +
to the dedicated subwoofer output
5
Center
Center
– +
LFE/Trigger Cable
(Purple Ends)
Surround Right
Speaker Cable
(Gray Bands)
Connect each satellite speaker and the center speaker to the corresponding speaker
terminals on your receiver or amplifier.
In your receiver or preamp/processor's setup menu, configure it for Subwoofer ON, and
set the front left, front right, center, and surround speakers to Small. After you have made
and verified all connections, plug the HKTS200SUB's AC Power Cord
outlet.
8 8
Right Front
Front Right
Speaker Cable
(Red Bands)
– +
Subwoofer
– +
Right
Surround
PL0004-01001
PL0004-01001
into an active AC
8