Harman Kardon HKTS1 Owner's Manual
Harman Kardon HKTS1 Owner's Manual

Harman Kardon HKTS1 Owner's Manual

Harman-kardon home theater system - surround sound speaker system user manual

Advertisement

HKTS1
OWNER'S MANUAL
Power for the digital revolution.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HKTS1 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Harman Kardon HKTS1

  • Page 1 HKTS1 OWNER’S MANUAL Power for the digital revolution. ™...
  • Page 2 Read First! Important Safety Precautions! 1. Read Instructions. All the safety and operating instructions should be read before the product is operated. 2. Retain Instructions. The safety and operating instructions should be retained for future reference. 3. Heed Warnings. All warnings on the product and in the operating instructions should be adhered to.
  • Page 3 electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits, as contact with them might be fatal. 18.
  • Page 4 INCLUDED Five satellites – with wall-mount brackets – for left, right, center and surrounds. Powered subwoofer. Three 20' speaker cables for connection from receiver to subwoofer. Three 15' speaker cables for connection from subwoofer to front satellites. Two 40' speaker cables for connection from receiver to rear satellites.
  • Page 5: Speaker Placement

    SPEAKER PLACEMENT Satellites Surround Speakers Subwoofer...
  • Page 6: Mounting Options

    Slide speaker onto support. Place speaker and support on wall plate. Note: The HKTS1 satellites feature a 5mm threaded insert on their back. Using this provision, the satellites can be used with ®...
  • Page 7: Speaker Connections

    SPEAKER CONNECTIONS Connection Tips Separate and strip the ends of the speaker wire as shown. Speakers and electronics terminals have corresponding (+) and (–) terminals. The (+) lead of the speaker wire is noted with a stripe. It is important to connect both speakers identically: (+) on the speaker to (+) on the amplifier and (–) on the speaker to (–) on the amplifier.
  • Page 8: Line Level

    Line Level Center Left Front Subwoofer Line- Level Input Left Sub- Front woofer Left Rear Center Receiver Left Surround Right Front Right Front Right Rear Right Surround...
  • Page 9: Operation

    OPERATION Mode Procedure Receiver/amplifier off. Receiver/amplifier on and playing program material. Standby Simply turn off your receiver/amplifier. The subwoofer will turn off after approximately twenty minutes. The subwoofer will turn on when your receiver/amplifier begins playing again. Volume LED Status Green...
  • Page 10: Troubleshooting

    TROUBLESHOOTING If there is no sound from any of the speakers, check the following: • Receiver/amplifier is on and a source is playing. • Powered subwoofer is plugged in and is either in the “On” or “Auto” position. • Check all wires and connections between receiver/amplifier and speakers.
  • Page 11: Specifications

    SPECIFICATIONS HKTS1 System Frequency Response 35Hz – 20kHz (–6dB) Refinements may be made on occasion to existing products without notice, but will always meet or exceed original specifications unless otherwise stated. Sat-TS1 Recommended Power 10 – 50 watts Nominal Impedance...
  • Page 12 250 Crossways Park Drive, Woodbury, New York 11797 1-800/422-8027 (USA only) Fax: 516/682-3523 © 1999 Harman Kardon, Incorporated “Monster Mount” is a registered trademark of Monster Cable Products, Inc. *Trademark of Dolby Laboratories. Printed 6/99 Part No. HKTS1OM...

This manual is also suitable for:

Sat-ts1

Table of Contents

Save PDF