Toshiba RDXV60KB Owner's Manual page 70

E3TK6BD_EN.book Page 70 Wednesday, February 17, 2010 10:18 AM
G Still Mode (Default: Auto) (DVD only)
Still Mode
Auto
Field
Frame
Auto : Automatically select the best resolution setting
("Frame" or "Field") based on the data
characteristics of the pictures.
Field : Select "Field" when the pictures are still
unstable even if "Auto" is selected. "Field"
stabilises the pictures, although the picture
quality may become coarse due to the limited
amount of data.
Frame : Select "Frame" to display relatively motionless
pictures in higher resolution. "Frame" improves
the picture quality, although it may unstabilise
the pictures due to simultaneous output of two
Field data.
Note
• An individual picture on TV screen is called as Frame,
which consists of two separate images called as Field.
Some pictures may be blurred at the "Auto" setting in still
mode due to their data characteristics.
H Variable Skip/Replay
Assign [VARIABLE SKIP] or [VARIABLE REPLAY] to
skip or rewind by a certain amount of time when they are
pressed.
Variable Skip/Replay
A
Variable Skip
B
Variable Replay
Refer to the explanations below and set the selected item.
A: Variable Skip (Default: 30 seconds)
Sets the amount of skip time for [VARIABLE SKIP].
Variable Skip
5 seconds
15 seconds
30 seconds
1 minute
5 minutes
B: Variable Replay (Default: 30 seconds)
Sets the amount of rewind time for [VARIABLE REPLAY].
Variable Replay
5 seconds
15 seconds
30 seconds
1 minute
5 minutes
I TV System (Default: PAL) (DVD only)
TV System
PAL
Auto
PAL : Outputs a modified PAL signal for viewing discs
recorded with the NTSC system on a PAL
system TV.
Auto : Changes the video system (PAL / NTSC)
automatically according to the format of the
inserted disc.
70
EN
Note
• With discs recorded using the PAL system, a PAL signal
is output for viewing on a PAL system TV.
• Discs recorded with the PAL system cannot be viewed
on an NTSC system TV.
• With discs recorded using the NTSC system, an NTSC
signal is output for viewing on an NTSC or Multi system
TV.
• With discs recorded using the NTSC system, select PAL
to view on a PAL system TV.
Display
Setup General Setting Display
A Screen Saver
B FL Dimmer
A Screen Saver (Default: 10 minutes)
Set the screen saver time delay.
Screen Saver
OFF
1 minute
5 minutes
10 minutes
15 minutes
B FL Dimmer (Default: Bright)
Set the front panel display brightness.
FL Dimmer
Bright
Dark
Note
• The display will not light up when the unit is in standby
mode. This is a Power Saving mode (ECO) for standby.