Usb Configuration - Gigabyte G293-Z20-AAP1 User Manual

Parameter

USB Configuration

USB Module Version
USB Controllers
USB Devices:
Legacy USB Support
XHCI Hand-off
USB Mass Storage Driver
Support
(Note)
USB hardware delays and
time-outs
USB transfer time-out
Device reset time-out
Device power-up delay
Mass Storage Devices
(Note) This item is present only if you attach USB devices.
Description
Displays the USB module version information.
Displays the supported USB controllers.
Displays the USB devices connected to the system.
Enable/Disable the Legacy USB support function. AUTO option disables
legacy support if no USB devices are connected. DISABLE option will keep
USB devices available only for EFI applications.
Options available: Enabled, Disabled, Auto. Default setting is Enabled.
Enable/Disable the XHCI Hand-off support.
Options available: Enabled, Disabled. Default setting is Enabled.
Enable/Disable the USB Mass Storage Driver Support.
Options available: Disabled, Enabled. Default setting is Enabled.
Selects the time-out value for USB Control/Bulk/Interrupt transfers.
Options available: 1 sec, 5 sec, 10 sec, 20 sec.
Default setting is 20 sec.
Selects the time-out value during a USB mass storage device reset.
Options available: 10 sec, 20 sec, 30 sec, 40 sec.
Default setting is 20 sec.
Maximum time the device will take before it properly reports itself to the
Host Controller. "Auto" uses default value: for a Root port it is 100 ms, for a
Hub port the delay is taken from Hub descriptor.
Options available: Auto, Manual. Default setting is Auto.
Displays the mass storage devices available on the system.
BIOS Setup
- 73 -