Epson UB-E02 User Manual page 3

Hide thumbs Also See for UB-E02:

How to Set Up the UB-E02

Preparation

Printing a Status Sheet

Power on the printer. Then, hold down the push button on the interface card

for more than 3 seconds. The printer prints the parameters for the UB-E02. You

can check all setting values necessary (IP address, Subnet mask, Gateway

address) for the network connection.

Connection

Set the setting of the host PC to match the network setting that you have

confirmed with the status sheet.

You can check whether the connection to the printer has been correctly done

by inputting the ping command through the command prompt.

Example: Ping 192.168.192.168

Note:

Although the example shows the address 192.168.192.168, use whatever IP address is

reported on the status sheet.

Because the default IP addresses for all the printers are the same, you should power on

and configure only one printer at a time.

Resetting the UB-E02 to Factory Defaults

Hold down the push button on the interface card while turning on printer

power and continue to hold it down for 5 seconds. This causes all internal

settings to return to their factory defaults.

Host Operating System

Windows

because these operating systems have built-in TCP/IP support.

Setup

There are two ways for the setup. For details, see the UB-E02 Technical

Reference Guide.

❏

Using a Web browser

Start Windows Internet Explorer (or your Web browser.)

Input the IP address of the UB-E02 in the browser address bar and

press Enter (Example: http://192.168.192.168 [default]).

The browser displays an opening screen.

You can modify the parameters by following the menus. You must

click Submit to send the change to the printer and then click Reset to

make the submission effective on each Web page. If you change the IP

address, etc., you have to change the setting of the host PC to match

the printer's setting.

XP and 2000 are the recommended host PC operating systems