Replacing the touch module
6. Disconnect the cable from the camera.
4. Connect the cable to the new camera.
5. Align then screw in the new camera.
6. Align then screw back the shell.
7. Install the computer cover and screw back the computer stand.
To replace the touch module:
1. Remove the computer stand. Refer to "Removing the computer stand".
2. Remove the computer cover. Refer to "Removing the computer cover".
3. Remove the screw that secures the touch module cover to the
chassis.
4. Slide out the touch module cover.
5. Remove the screw that secures the touch module to the chassis and
lift it up.
Chapter 8. Replacing hardware
53