Replacing the bluetooth module
6. Slide the hard disk drive out of the bay.
1
7. Install the new hard disk drive.
(1) Slide the new hard disk drive into the drive bay.
(2) Screw back the 4 screws on the drive bay.
8. Connect the data and power cables back to the hard disk drive.
9. Align the 4 screw holes in the hard disk drive bay with the mounting
holes in the chassis, then screw it back.
10. Install the computer cover and stand.
To replace the bluetooth module:
1. Remove the computer stand. Refer to "Removing the computer stand".
2. Remove the computer cover. Refer to "Removing the computer cover".
3. Remove the tape on the top of the bluetooth module.
4. Pull the pins to each side to release the bluetooth module.
5. Lift up the bluetooth mudule.
2
1
Chapter 8. Replacing hardware
1
1
39