Panasonic KX-MB783BR Service Manual page 71

8.1.3. DOCUMENTS THE UNIT CAN SEND
Note:
• Confirm that there are no documents on the scannerglass.
• Check that ink, paste or correction fluid has dried completely.
• Remove clips, staples or other fasteners.
• Do not set the following types of documents: (Make a copy of the document using the scanner glass and set the copy instead.)
-Chemically treated paper such as carbon or carbonless duplicating paper
-Electrostatically charged paper
-Badly curled, creased or torn paper
-Paper with a coated surface
-Paper with printing on the opposite side that can be seen through the other side, such as newsprint
• The total height of the documents when laid flat, must be less than 4 mm. If the documents exceed the capacity of the auto doc-
ument feeder, they may fall or cause a jam in the feeder.
• To set a document with a width of less than 210 mm, we recommend using the scanner glass to copy the original document onto
A4 or letter-sized paper, then setting the copied document.
• Do not set documents that do not satisfy the requirements of size and weight. Make a copy of the document using the scanner
glass and set the copy.
• Available document size, document weight and effective scanning area are as follows:
8.1.3.1. Using the auto document feeder
8.1.3.2. Using the scanner glass
Note:
• Confirm that there are no documents in the auto document feeder.
• Place the original onto the scanner glass gently and do not press down too firmly to avoid malfunction.
• If the original is a thick book, do not close the document cover.
• Check that ink, paste or correction fluid has dried completely.
• Effective scanning area is as follows:
Effective scanning area
71
KX-MB783BR