D-Link DUB-E100 User Manual page 10

Section 2 - Installation
3. When the Windows driver installation is complete, attach an Ethernet cable to the Ethernet port on the DUB-E100.
4. Attach the other end of the Ethernet cable to your network switch or router.
5. When the installation of the DUB-E100 is complete, the Speed LED will illuminate solid green when the DUB-E100 is
connected to a 100 Mbps network and remains off when connected to a 10 Mbps network. The Tx/Rx LED will flash amber
when data is being transmitted or received. If both LEDs are unlit, there may be a problem with the physical connection.
Check the cables between your DUB-E100 and your switch or router. Verify that your network switch or router is powered
on.
D-Link DUB-E100 User Manual 7