Sennheiser evolution wireless G3 EW 100-935 G3-B-X Instruction Manual page 31

Cleaning the devices
Problem
No RF signal at the
receiver
RF signal available,
no audio signal,
"MUTE" appears on the
display panel of the
receiver
Audio signal has a high
level of background noise
or is distorted
30
Possible cause
Bodypack transmitter/radio microphone
and receiver are not on the same channel
Bodypack transmitter/radio microphone
is out of range
RF signal is deactivated ("RF
Bodypack transmitter/radio microphone
is muted (MUTE)
Receiver's squelch threshold is adjusted
too high
Bodypack transmitter/radio microphone
doesn't transmit a pilot tone
Bodypack transmitter's/radio micro-
phone's sensitivity is adjusted too low/
too high
Possible solution
Synchronize the bodypack transmitter/radio
microphone with the receiver (see page 20).
Set the bodypack transmitter/radio micro-
phone to the same channel as the receiver.
Check the squelch threshold setting on the
receiver.
Reduce the distance between bodypack
transmitter/radio microphone and receiving
antenna.
Mute") Activate the RF signal (see page 23).
Cancels the muting (see page 22).
Reduce the squelch threshold setting on the
receiver.
Activate or deactivate the pilot tone transmis-
sion (see page 27).
Adjust the input sensitivity (see page 27).