Malfunction
Drum is spinning, er
no water flows into
the appliance.
strong foam
ming.
|
i-Dos
can not
be pressed
High spin speed
rental is not
reached.
Program centrifugal
run does not start.
Cause and Troubleshooting
Load recognition is active.
No error, no action necessary.
▶
Remark: The load detection can take up to 2 minutes.
Detergent dosage is too high.
Immediate measure: mix a tablespoon of fabric softener
▶
ter with 0.5 l of water and pour this mixture into
the manual dosing compartment (not for outdoor,
sportswear and down textiles).
When the intelligent dosing is activated, re-
▶
then induce the basic dosing amount
→ Page 43.
When dosing manually, reduce to the full
▶
next wash with the same load the amount of
detergent.
Intelligent dosing is not possible for this program.
No error - no action required.
▶
Program progress does not allow intelligent dosing.
No solution possible.
Low spin speed is set.
For the next wash, set a higher spin
▶
speed in.
Unbalance control system compensates for
imbalance through reduced spin speed.
Redistribute the laundry in the drum.
▶
Remark: If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes is more evenly distributed when spinning.
Start the program Centrifuge.
▶
Drain pipe or water drain hose is clogged.
Clean the drain pipe and the water drain hose.
▶
Drain pipe or water drain hose is kinked or
pinched.
Make sure that the drain pipe and water drain
▶
feed hose is not kinked or pinched.
The unbalance detection system has aborted the spin
due to uneven distribution of the laundry.
Redistribute the laundry in the drum.
▶
Troubleshooting NL
59