Installation - Smeg KSET62T Instruction On Mounting And Use Manual

with these instructions may result in
electrical hazards.
• Do not use or leave the hood without
the lamp correctly mounted due to the
possible risk of electric shocks.
• Never use the hood without effectively
mounted grids.
• The hood must NEVER be used as a
support surface unless
indicated.
• Use only the fixing screws supplied with
the product for installation or, if not
supplied, purchase the correct screws
type.
• Use the correct length for the screws
which are identified in the Installation
Guide.
• In case of doubt, consult an authorized
service assistance center or similar
qualified person.
WARNING! Do not use with a
programmer, timer, separate remote
control system or any other device that
switches on automatically.
WARNING: Incorrect placement of
screws or fasteners or mounting devices
according to these instructions may result
in electrical hazards.
CAUTION: Accessible parts of the hood
may become hot when used with cooking
appliances.
Electrical connection
The mains power
correspond to the rating indicated on the
plate situated inside the hood. If provided
with a plug connect the hood to a socket
in compliance with current regulations
and positioned in an accessible area,
after installation. If it not fitted with a plug
(direct mains connection) or if the plug is
not located in an accessible area, after
installation, apply a double pole switch in
accordance
assures the complete disconnection of
the mains under conditions relating to
over-current category III, in accordance
specifically with installation instructions.
hood circuit to the mains supply and
checking the efficient function, always
check that the mains cable is correctly
assembled.
The hood is provided with a special
power cable ; if the cable is damaged,
request a new one from Technical
Service.
It is the customer's responsibility: To contact a qualified
electrical installer.
CUSTOMER SERVICE: 800-111-7634
WHATSAPP CUSTOMER SERVICE: 5540677705
SCHEDULE: Monday to Friday from 9:00 a.m. to 6:00 p.m.
Saturdays: 9:00 a.m. to 2:00 p.m.

Installation

• The minimum distance between the
supporting surface for the cooking
equipment on the hob and the lowest part
of the range hood must be not less than
50cm from electric cookers and 65cm
from gas or mixed cookers.
If the instructions for installation for the
gas hob specify a greater distance, this
supply must
must be adhered to.
3
with standards
WARNING! Before re-connecting the
which